Airmar GH2183, GPS & Heading Sensor Manual de usuario descargar pdf (Pagina 6)

Cables & Connecting/Converting Hardware

The Compass with GPS Receiver (sensor) can be connected in several ways.

You must have the correct cable and any needed hardware before beginning

the installation.

Sensor Cables Length Part No.

• NMEA 0183 Cable 10m 33-862-02

• NMEA 2000® Cable 6m 33-1029-02

• NMEA 2000® Cable 10m 33-1029-06

NOTE: Additional cable lengths are available.

Connecting/Converting Hardware Length Part No.

• NMEA 0183 to USB, Data Converter 33-801-01

• NMEA 0183 to USB Combiner NDC-4-AIR

• NMEA 2000® CAN to USB, U200 Gateway 33-727-01

• NMEA 0183 & NMEA 2000® Splitter 15m 33-641-02

• NMEA 0183 & NMEA 2000® Splitter 30m 33-641-03

Tools & Materials

CAUTION: Vehicles/boats traveling above 30MPH—Do not use the plastic

Cable Side-exit Adaptor (part D) supplied. Purchase a stainless steel part. At high

speeds, the plastic adaptor may break, causing the sensor to fall off.

NOTE: The sensor has standard marine 1"-14 threads.

Pole/rail mounting hardware (some installations)

Safety goggles

Dust mask

Screwdrivers (Pole/Rail Mount installation)

Teflon pipe-thread tape, 1/2" wide (some installations)

Pencil (some installations)

Electric drill (some installations)

Drill bits and hole saws (some installations):

Pilot hole 3mm or 1/8"

Flush mount stud holes 6mm or 1/4"

Flush mount cable hole 38mm or 1-1/2"

Loctite® 242® or other removable thread locker (Flush Mount installation only)

Grommet(s) (some installations)

Cutting pliers (some installations)

Heat-shrink tubing (some installations)

Heat gun (some installations)

Wire strippers (some installations)

Cable ties (some installations)

Multimeter (some installations)

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sin comentarios

Airmar GH2183, GPS & Heading Sensor Manual de usuario Pagina 6